Maintenance And Cleaning; Regular Maintenance - Krups ESPRESSERIA AUTOMATIC EA 80 Serie Mode D'emploi

Falcon Display Tu?v 0827932:Mise en page 1

5 Maintenance and cleaning

Danger : Any contact of the conduc-
tive parts of the appliance with humidity
or water may lead to fatal injuries due to
the presence of electricity!
Before cleaning your machine, unplug it
from the mains socket and leave it to cool
down.
Before moving or tilting the appliance,

5.1 Regular maintenance

Certain parts of your machine require re-
gular maintenance :
The used coffee collector (7) : the
used coffee collector collects the used
coffee. On the screen, a message indi-
cates when the collector needs to be
emptied. In general it needs to be emp-
tied after preparing 9 coffees. From time
to time, pass the collector under running
water to clean it. Dry it thoroughly.
!
Important : Ensure that the used cof-
fee collector is completely emptied to
avoid any overflow. If the collector is not
fitted correctly, the warning message will
remain on the screen. If the used coffee
collector is fitted in less than 6 seconds,
the appliance will ask for confirmation,
using the OK button, that it has been
emptied. No preparations can be made
until the message is cleared.
The cleaning drawer (8) : this drawer
is used to eliminate any deposits of used
coffee from the appliance. Remove the
cleaning drawer before emptying the
used coffee collector. If the drawer is
very dirty, pass it under running water
then dry it.
The drip tray (23) : the drip tray collects
the used water as well as water spilt du-
10/03/08
ensure that the drip tray is empty to avoid
water or the cleaning or descaling pro-
duct from being spilt.
steam nozzle, water may be splashed
quite forcefully. Place a paper towel on
the drip tray and the steam nozzle.
ring preparations. A message on the
screen indicates when the tray needs to
be emptied. The appliance also has a me-
chanical water gauge (22). If the tray is
dirty, clean it by passing it under running
water.
Coffee circuit : the coffee circuit pipes
must be rinsed if the appliance has not
been used for several days.
Every time that the appliance is switched
on, a message on the screen asks if you
wish to rinse it (rinsing procedure, see
point 3.4).
Ensure that the steam nozzle (21) is
cleaned thoroughly after several uses: re-
move it and pass it under running water.
It may be removed for cleaning (see illus-
tration). Use a rinsing brush and a little
washing up liquid. Dry all parts tho-
roughly and ensure that the air inlets are
not blocked. Use the cleaning wire sup-
plied with your machine to unblock the
holes if necessary.
Use and maintenance / SERIE EA 80xx
13:51 Page 27
KRUPS Espresseria Automatic
i
Tip : When cleaning or descaling the
27