Safety Instructions - Wallbox Pulsar Plus Guide D'installation

EN
GETTING STARTED

Safety instructions

SAVE THESE INSTRUCTIONS | INSTRUCTIONS PERTAINING TO RISK OF FIRE OR ELECTRIC SHOCK.
WARNING: When using electric products, basic precautions should always be
followed, including those below. This manual contains important instructions that
cover the safe installation, operation and maintenance of the unit.
• Read all instructions before installing and using your Wallbox charger.
• Permanent (hardwired) connection of your charger and/or installation of
electrical circuits, conduit, and NEMA receptacles must only be performed by a
qualified electrician in accordance with all local electrical codes and ordinances.
Unauthorized installation or modifications will void the manufacturer's warranty.
• This device should be supervised when using around children.
• Do not put fingers into the electric vehicle connector.
• Do not use your Wallbox charger if the flexible power cord or EV cable is frayed,
has broken insulation, or any other signs of damage.
• Do not use your Wallbox charger if the enclosure or the EV connector is broken,
cracked, open, or shows any other indication of damage.
• Do not operate your Wallbox charger in temperatures outside its operating range
of -22ºF to 104ºF (-30ºC to 40ºC).
• Do not open your charger in rain or other inclement weather.
• Do not open the front cover of your charger while it is connected to the power
supply.
• Install your charger in a sufficiently ventilated location and avoid installation
in areas with direct sunlight.
• Do not install your Wallbox charger near flammable, explosive, or combustible
materials.
• All documents can also be found online at support.wallbox.com/na
• In case of flooding, do not operate your charger while it or your vehicle is
submerged in water.
• If your charger was submerged in water due to flooding, have a qualified
electrician inspect your charger prior to energizing or using your charger again.
Warning for Wallbox AC plug-in products: Grounding instructions
Your Wallbox charger must be grounded. If it should malfunction or break down, grounding
provides a path of least resistance for electric current to reduce the risk of electric
shock. Your charger is equipped with a cord having an equipment grounding conductor
and a grounding plug. The plug must be plugged into an appropriate receptacle that is
properly installed and grounded in accordance with all local codes and ordinances.
WARNING: Improper connection of the equipment-grounding conductor may
result in a risk of electric shock. Check with a qualified electrician or service
person if you are in doubt as to whether the product is properly grounded. Do not
modify the plug provided with the product. If it does not fit the receptacle, have a
proper receptacle installed by a qualified electrician.
4