Operating; Powering On; Guide To Leds; Registering And Connecting - Wallbox Pulsar Plus Guide D'installation

INSTALLATION

Operating

NOTE: Once you have powered on the connected circuit, your charger will be ready to charge your EV. To
fully access your charger functions and control your charger remotely, however, you will need to download the
myWallbox app to a mobile device (smartphone or tablet) and register your charger following the directions below.
PN:XXXX-X-X-X-X-XXX-X
----
E506750 EVSAE

Powering on

If you have installed a NEMA plug-in model,
insert the NEMA plug in the receptacle.
For all models, once all electrical connections
have been safely made, switch on the power to
the circuit from the circuit breaker.
The charger LED ring should light up in a steady
green. If the LEDs are not lighting, power off the
circuit at the circuit breaker and contact your
electrician to ensure proper electrical installation.

Guide to LEDs

Green: Ready.
Light blue: Connected to EV, ready for charge.
Dark blue (pulsing): Charging.
Yellow: Locked.
Red: Error (see troubleshooting section on page 18).
Registering and
connecting your charger
Download the myWallbox app to your
smartphone or tablet, log in and follow the
on-screen instructions to create an account
and register your charger. You will need to
verify your account with a valid email address.
Once you have created your account, launch
the app and follow the on-screen instructions
for connecting to and registering your charger.
To connect your charger, you will need to
enter the serial number (SN) and unique
identification number (UID). This information
may be found on your charger label.
If you have any difficulty connecting your
charger to your myWallbox app, please refer
to the "Help & Support" link on the app under
your user profile. If you have trouble with the
app, please go to support.wallbox.com/na.
EN
17