Mounting - Wallbox Pulsar Plus Guide D'installation

INSTALLATION
NEMA plug-in installation
3.
Drill two holes with an appropriate sized bit.
Place the wallplate in alignment with the holes.
If you are mounting your charger on a solid wall,
use the wall anchors provided with your charger.
x2
4.
Firmly mount the wallplate using the provided
wall screws. Do not over-tighten the screws.
x2
ø6 x 50mm

Mounting

1.
Carefully remove your charger from the
packaging box and hang your charger from the
top of the wallplate.
2.
Secure the charger to the wallplate using
the provided wallplate screws. Do not over-
tighten.
x2
ø3.5 x 9.5mm
Proceed to the instructions for installing the
holster and operating your charger, pages 16-17.
EN
11