Resetting The Camera - Panasonic Homehawk Shelf Guide D'utilisation

Back
RESET button
Speaker
SETUP button
micro-USB connector
Used to connect the AC
adaptor to the camera�
Temperature sensor
HNC815C_ITG_(en_en)_0424_ver.040.pdf 5
R
esetting the camera
Use this procedure if you have trouble setting
up the camera�
1
Plug in the camera�
• Wait for about 1 minute until the
camera beeps�
Using an object with a thin tip‚ press and
2
RESET
hold button on the back of the
camera until the camera beeps (about
5 seconds)�
• The camera's settings are reset�
3
Wait for the camera's LED to light in
yellow�
Note:
• After resetting‚ perform the initial setup to
use the camera�
For more information‚ access the User's
Guide (page 3)�
5
2019/04/24 18:22:46