Led Indicator - Panasonic Homehawk Shelf Guide D'utilisation

LED indicator

Off
Yellow‚ lit
Green‚ blinking quickly
Green‚ lit
Red‚ lit
Blue‚ lit
Yellow‚ blinking slowly
Green‚ blinking slowly
Red‚ blinking
White‚ lit
Red‚ blinking slowly
White‚ blinking slowly
You can configure the camera so that its LED indicator does not light during normal operation. For more
*1
information‚ access the User's Guide (page 3)�
The signal level (strong‚ good‚ weak‚ out of range) is shown for 3 seconds after pressing
*2
Lights for 3 seconds after registration is successfully completed or failed�
*3
6
HNC815C_ITG_(en_en)_0424_ver.040.pdf
Status
• No power
• LED indicator is turned off
Not registered to your wireless router (usually for initial setup) or signal level is good
Camera is searching for your wireless router
Registration successfully completed
*3
Registration failed ‚ signal level is weak
Registration to your wireless router successfully completed or camera is on
Initial setup is being performed using WPS on your router
Registration mode or updating
• Camera is out of range of your wireless router
• Wireless LAN connection failed
*1
Privacy mode is on
*1
• Streaming data or detecting motion
• Accessing microSD card (when privacy mode is off)
Accessing microSD card (when privacy mode is on)
6
*1
*3
or signal level is strong
*2
*2
*1
*2
*2
*1
SETUP
button�
2019/04/24 18:22:46