Maintenance And Servicing - Power Fist 8974289 Manuel D'utilisateur

8974289
allow access by children or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach the work area without
creating a tripping hazard or exposing the power cord to possible damage.
The power cord must reach the work area with enough extra length to
allow free movement while working.
3. There must not be objects, such as utility lines, nearby that will present a
hazard while working.
GENERAL OPERATING INSTRUCTIONS
NOTICE! The Belt Sander is designed to sand only workpieces made of wood.
CAUTION! Do not sand stock that is too small to be safely supported or held.
Sand those pieces by hand.
1. Plug Sander into wall socket (or extension cord) containing grounding
prong.
2. Turn on Power Switch momentarily to verify that Sanding Belt is tracking
properly. If Belt tracking needs adjustment, turn Belt Sander off and refer
to Figure E. If the Sanding Belt is rotating properly with proper tracking, the
Belt Sander is ready for use.
3. Turn on Power Switch.
4. Push workpiece against belt gradually to start sanding. Keep hands clear
and do not apply excessive force.
CAUTION! Do not apply too much pressure on object being sanded that it
inhibits rotation of sanding belt. Keep fingers away from the sanding belt.
5. To prevent accidents, turn off the tool and disconnect its power supply
after use. Clean, then store the tool indoors out of children's reach.

MAINTENANCE AND SERVICING

WARNING! Procedures not specifically explained in this manual must be
performed only by a qualified technician.
WARNING! Turn the Power Switch of the tool off and unplug the tool from its
electrical outlet before performing any procedure in this section.
NOTICE! Do not use damaged equipment. If abnormal noise or vibration
12
1 in. Belt Sander
For technical questions call 1-800-665-8685
V4.0