Power Fist 8974289 Manuel D'utilisateur page 10

8974289
Moving guards must move freely and close instantly.
REMOVING AND INSTALLING SANDING BELT
1. Remove the Guard Knob (44), then
remove the Side Guard (43).
2. Turn the Tracking Knob (18)
counterclockwise to loosen the
Sanding Belt (42).
3. Remove the Sanding Belt.
4. Place the new Sanding Belt on the
three pulleys. Center the Sanding
Belt on the pulleys.
5. Tighten the Sanding Belt by turning the Tracking Knob clockwise until the
rear Driven Wheel (10) appears centered.
6. Replace the Side Guard and Guard Knob.
7. Check and adjust Sanding Belt tracking before use as explained in the
following section.
ADJUSTING THE SANDING BELT TRACKING
1. Turn the Belt Sander on.
2. Look at the Sanding Belt (42)
through the Spark Guard (34):
a. If it is riding on the center of
the upper Driven Wheel (10)
the tracking is correct and no
further adjustment is required.
b. If the Belt rides to the left, turn
the Tracking Knob (18)
gradually counterclockwise until the Belt is centered.
c. If the Belt rides to the right, turn the Tracking Knob (18) gradually
clockwise until the Belt is centered.
10
1 in. Belt Sander
For technical questions call 1-800-665-8685
V4.0