Tool Set Up - Power Fist 8974289 Manuel D'utilisateur

V4.0
2. Remove the Bolt (45) from the
Locking Handle (29). See Figure B.
IMPORTANT! Do not lose the Toothed
Washer (27) under the Locking Handle
(29).
3. Place the Table (40) on the Frame (14)
so that the Sanding Belt (42) fits
through the slot in the Table. See
Figure B.
4. Replace the Bolt (45) and secure it using the Toothed Washer (27) and
Locking Handle (29). See Figure B.
5. Replace the Side Guard (43) and secure it using the Guard Knob (44).
6. Loosen the Screw (32) shown in Figure C.
7. Place the Spark Guard (34) on the top of
the Frame and secure using the Screw
(32). See Figure C
8. Place the Belt Sander on a secure
workbench able to carry the weight of the
Belt Sander and stock.
9. Attach the vacuum hose (if used) to the 1-
3/4" dust port on the Side Guard. See
Figure A. Otherwise, attach a vacuum bag (not supplied) to the port to
collect the dust.
OPERATING INSTRUCTIONS
WARNING! Read the entire important safety information section at the
beginning of this manual including all text under subheadings therein before
set up or use of this product.

TOOL SET UP

WARNING! Turn the Power Switch of the tool off and unplug the tool from its
electrical outlet before performing any procedure in this section.
CAUTION! Do not operate with any guard disabled, damaged, or removed.
Visit www.princessauto.com for more information
1 in. Belt Sander 8974289
9