Inspection, Maintenance And Cleaning - Power Fist 8155558 Manuel Du Propriétaire

8. Do not force the belt sander to remove material faster than it is designed to. Push and pull the
sanding belt gradually along the surface of the work piece.
9. Once the sanding job is completed, turn off the belt sander and wait until the sanding belt stops
turning. Then unplug the power cord from its electrical outlet.

INSPECTION, mAINTENANCE ANd ClEANINg

warnInG:
ensure the power switch of the belt sander is in it's OFF position and that the tool is unplugged
from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
1. Carbon brushes. To maintain peak efficiency of the belt sander motor it is recommended that every
two to six months the carbon brushes be examined. The carbon brush should be free of dust and dirt.
The carbon brush should be replaced when it wears down to 3/16" in length. The carbon brush should
slide freely in and out of the brush holder without sticking. To check the carbon brush, remove the brush
holder cover located at the front of the belt sander. Lift out the carbon brush to inspect. If cleaning is
necessary, rub the carbon brush thoroughly with a pencil eraser. Next, clean the brush holder opening
with compressed air or a clean cloth. Then replace the carbon brush and the cover.
2. the ventilation openings should be kept clean and free of sawdust and debris. The most effective
way to clean the ventilation openings with is with compressed air. The outer body may be cleaned with a
clean cloth and a mild detergent. Do not use solvents. Do not immerse in liquids.
For any technical questions, please call 1-800-665-8685
5