Power Fist 8974289 Manuel D'utilisateur page 8

8974289
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
IDENTIFICATION KEY
ASSEMBLY
CAUTION! Turn the Power Switch of the tool off and unplug the tool from its
electrical outlet before performing any procedure in this section.
IMPORTANT! For additional information regarding the parts listed in the
following pages, refer to the Assembly
Diagram near the end of this manual.
1. Remove Guard Knob (44) and take off the
Side Guard (43). See Figure A.
8
1 in. Belt Sander
For technical questions call 1-800-665-8685
V4.0