Power Fist 8974289 Manuel D'utilisateur page 11

V4.0
ADJUSTMENT OF BELT SUPPORT
1. Remove the Table (40) by removing
the Bolt (45) and Locking Handle
(29), as shown.
2. Loosen the two Cap Screws (38) on
the Belt Support (35).
3. Adjust the Belt Support to no farther
than 1/16" from the back of the
Sanding Belt.
4. Tighten the two Cap Screws on the
Belt Support.
5. Replace the Table and tighten it in place.
ADJUSTING TABLE ANGLE
1. Loosen the Locking Handle (29) by
turning it counterclockwise.
2. Tilt the Table (40) to the desired
angle. Use a protractor to ensure
accuracy. There should be no more
than 1/16" distance between the
Table and the Sanding Belt (42).
3. Tighten the Locking Handle.
LEVELING THE TABLE
1. Loosen the Locking Handle (29) by turning it counterclockwise, and lean
the table as far back as possible.
2. Using a square (sold separately), verify that the Table is 90° to the belt.
3. If the Table is tilted toward the front of the machine, tighten the Set Screw
(39).
4. If the Table is tilted toward the back of the machine, loosen the Set Screw.
5. Tighten the Locking Handle.
WORKPIECE AND WORK AREA SET UP
1. Designate a work area that is clean and well-lit. The work area must not
Visit www.princessauto.com for more information
1 in. Belt Sander 8974289
11