Sander Safety Warnings - Power Fist 8974289 Manuel D'utilisateur

8974289

SANDER SAFETY WARNINGS

1. Wear eye protection.
2. Support workpiece with miter gauge, backstop, or worktable.
3. Maintain 1/16 inch maximum clearance between table and sanding belt or
disc.
4. The backstop is a fence near the surface that helps the operator maintain
control of the workpiece and prevents the workpiece from being pulled into
the machine. For safety, it must be adjusted very close to the sanding
surface.
5. The worktable is the surface mounted close to the sanding surface that the
operator rests the workpiece against to prevent it from being pulled by the
sanding surface. For safety, it must be adjusted very close to the sanding
surface.
6. The sanding belt is designed to rotate down towards the table while the disc
rotates both up from the table and down towards the table.
7. Do not operate with any guard disabled, damaged, or removed. Moving
guards must move freely and close instantly.
8. The use of accessories or attachments not recommended by the
manufacturer may result in a risk of injury to persons.
9. When servicing use only identical replacement parts.
10. Do not depress the spindle lock when starting or during operation.
11. Only use safety equipment that has been approved by an appropriate
standards agency. Unapproved safety equipment may not provide adequate
protection. Eye protection must be ANSI-approved and breathing protection
must be NIOSH-approved for the specific hazards in the work area.
12. Stay alert, watch what you are doing and use common sense when
operating a power tool. Do not use a power tool while you are tired or under
the influence of drugs, alcohol or medication. A moment of inattention while
operating power tools may result in serious personal injury.
13. Industrial applications must follow OSHA guidelines.
14. Maintain labels and nameplates on the tool. These carry important safety
information.
6
1 in. Belt Sander
For technical questions call 1-800-665-8685
V4.0