Dimensions - GOK GWS 904 Instructions De Montage Et De D'utilisation

Setting the telescopic tube
• Loosen the cap nut.
• Set the clearance between upper edge connecting fitting and lower edge dome
shaft cover to 20mm to 300mm by moving the telescopic tube.
• Tighten the cap nut by holding on the telescopic adapter piece.
• Do not move the telescopic tube with connector afterwards.
Assembly for dome shafts
The connector must be mounted directly next to the filling hole plug
The connector must be attached sufficiently so that it is possible to easily couple with the
connection line of the controller.
The cable (not included) must be routed in such a way that neither kinks nor pinching
spots are created, the insulation is not damaged and the line is attached sufficiently (every
50cm to 70cm one cable tie
Part No. 15 382 65
Limit indicator GWG - type GWS -issue 2

Dimensions

Probe length Z
700mm
1000mm
).
Telescopic length L
170 to 600mm
170 to 760mm
of the tank.
• Regarding tanks for storing non-
inflammable and inflammable
liquids with a flash point of >
55°C, the feedthrough
connection lines to the dome
shaft must be liquid-proof.
• Regarding tanks for storing
inflammable liquids with a flash
point of < 55°C, the feedthrough
of the connection lines to the
dome shaft must be gastight.
of the
19 / 24