4.2 STABILITY OF PLANTING UNIT AND TRACTOR
DURING TRANSPORT
I
R
I
=
F
T E
T F
T R
I R
I F
a
b
c
d
(*) See instruction handbook of the tractor.
T
E
F
R
T
F
a
b
cod. G19503392
USE AND MAINTENANCE
T
T
F
E
850
mm
T
R
I
R
c
d
4.3 TRANSPORT
Before proceeding to the hoisting op- erations, make sure
that any any mo- bile elements of the machine are blocked.
Make sure to use a crane with an adequate hoisting capacity
to lift the machine. Hoist the machine with extreme caution
and transfer it slowly, without jerks or abrupt movements.
The operations of hoisting and trans- port can be very dange-
rous if not carried out with the maximum caution; persons not
directly involved should be moved away. Clean, evacuate the
area and delimit the transfer zone. Check the state, condition
and suit- ability of the means at disposition. Do not touch
suspended loads, keep- ing them at a safe distance.
It most be further ascertained that the operational area is free
aning an area which is free and secure into which one could
move rapidly in case a load should fall. The surface on which
the machine is to be loaded must be horizontal in or- der to
prevent possible shifting.
Transit and transporting on the public highways
ATTENTION
The seed-drill must only be transported by road with the tanks
and hoppers empty and at max speed of 25 km/h.
Before driving on to the public roads with the machine hitched
to the tractor, make sure that the devices listed above and/or
the slow vehicle signal and/or the projecting load signal op-
of the implement in a position where they can be clearly seen
by any other vehicle that drives up behind.
ENGLISH
CAUTION
DANGER
-