mspa Alpine Manuel D'utilisation page 21

LED
READING
E1 immediately shows after pressing
FILTER or HEATING
E1
E1 shows 15s after pressing FILTER
or HEATING
PROBLEM
NO DISPLAY ON
THE CONTROL
PANEL
SPA LEAKING
NOT HEATING
PROPERLY
BUBBLE AIR
BLOWER DOES
NOT WORK
CAUSE
CAUSE
Power failure
PRCD is off
PRCD broken
Spa inlet/outlet connection not
securely tight
Drainage valve is not closed
completely
Water leaks from the spa
pool body
Temperature set too low
Heating element failed
Low water level
Bubble motor failure
Auto-off 10 minute
Inflation knob is in <ON> position
Clean parts and tubes that water goes through
1. Add more water to the minimum line;
2. Clean parts and tubes that water goes through;
3. Contact the MSpa Service Center.
Check power supply
Reset PRCD by following PRCD Testing
section
Contact the MSpa Service Center
Tighten the inlet and outlet connection by
wrench
Close the drainage valve. Contact the MSpa
Service Center, if spa is still leaking
Repair the leaking hole/spilt with the repair
kit material
Set a higher temperature
Contact the MSpa Service Center
Add more water to reach the minimum
water line
Contact the MSpa Service Center
Waiting for 10 minutes and turn on the
Bubble button again
Turn the knob to <OFF> position and turn
on the bubble button again.
21
SOLUTION
SOLUTION