Setting Of Parameters (Setup) - LOVATO ELECTRIC DMG800 Manuel D'application

10
– Data recorded by the DMG can be downloaded to the PC disk through a serial interface module.
– For detailed information about the setting of datalogger function see the manual of the DMK-DMG data logger software.
– Note: The memory module mandatory position is slot 1 of the DMG expansion bus (leftmost).
P R METER SETTING (SET-UP)
– From normal viewing, press MENU to recall the General menu, then select icon
– The display will show the table below, with the parameters grouped in sub-menus with a function-related criteria .
– Select the required menu with s t keys and confirm with
– To quit setup and go back to the readings viewing, press MENU.
– The following table lists the available sub-menus:
Code Sub-menu
M01 GENER L
M02 UTILITY
M03 P SSWORD
M04 INTEGR TION
M05 HOUR COUNTER
M06 TREND GR PH
M07 COMMUNIC TION (COMn)
M08 LIMIT THRESHOLDS (LIMn)
M09 L RMS ( L n)
M10 COUNTERS (CNTn)
M11 ENERGY PULSING (PULn)
M12 BOOLE N LOGIC (BOOn)
M13 INPUTS (INPn)
M14 OUTPUTS (OUTn)
M15 USER P GES (P Gn)
M16 N LOG INPUTS ( INn)
M17 N LOG OUTPUTS ( OUn)
– Select the sub-menu and press to show the parameters.
– Each parameter is shown with code, description and actual setting value.
1 - Parameter code
2 - Parameter description
3 - Present setting value
4 - Selected parameter
– To modify the setting of one parameter, select it and then press
– If the dvanced level access code has not been entered, it will not be possible to enter editing page and an access denied message will be shown.
– If instead the access rights are confirmed, then the editing screen will be shown.
1 - Selected parameter
2 - Minimum possible setting
3 - Graph bar of the value-range
4 - New value entered
5 - Maximum possible setting
7 - Factory default setting
– When the editing screen is displayed, the parameter setting can be modified with
s and t keys. The screen shows the new setting, a graphic bar that shows the setting range, the maximum and minimum values, the previous setting and
the factory default.
– Pressing simultaneously s and t, the setting is set to factory default.
– During the entry of a text string, keys s and t are used to select the alphanumeric character while
Pressing keys
s and t simultaneously will move the character selection straight to ' '.
– Press MENU to go back to the parameter selection. The entered value is stored.
– Press MENU again to save all the settings and to quit the setup menu. The multimeter executes a reset and returns to normal operation.
– If the user does not press any key for more than 2 minutes, the multimeter leaves the setup automatically and goes back to normal viewing.
and press to open the set-up menu screen.
.
Description
Detailed data of the installation
Language, backlight, display pages, etc.
ccess codes enabling
Readings integration time
Hour counter enabling
Trend graph reading and scale
Communication ports
Limit thresholds on readings
larm messages
General counters
Energy pulse count
Boolean logic variables
Digital inputs
Digital outputs
User-defined pages
nalog inputs
nalog outputs
.
is used to move the cursor along the text string.
G
B