Install The Lower And Upper Vents - Norcold N260.3 Manuel D'installation

Install the Lower and Upper Vents

1. Determine the rough opening (RO) size for each vent.
Certified Vent
Upper Side Exhaust Vent
Lower Side Intake Vent
Universal Upper and Lower Vent
2. Install the lower intake vent (See Art01634):
The lower intake vent is also the service access opening
NOTICE
for the components on the rear of the refrigerator.
Make sure the bottom of the opening for the
!
WARNING lower intake vent is even with or immediately
below the floor level. This allows any leaking
propane gas to escape to the outside and not to
collect at floor level.
- Make sure the bottom of the opening of the lower intake vent [9] is
even with or immediately below the floor level.
- Align the lower intake vent vertically below the coils [10] and the
condenser [11] of the refrigerator.
3. Install the upper exhaust vent (See Art01635):
For the best cooling performance, the distance
NOTICE
from the floor level to the top of the rough
opening [25] of the upper exhaust vent should
be 30 1/2 inches.
- Make sure the distance [25] from the floor level to the top
of the rough opening for the upper exhaust vent is at least
20 5/8 inches or poor cooling performance can occur.
- Align the upper exhaust vent [24] horizontally above
the lower intake vent of the refrigerator.
- Install a baffle [172] to prevent stagnant hot air in the
area [14] above the refrigerator.
- Make sure there is less than 1/4 inch clearance
[124] between the baffle and the top of the
refrigerator.
- Make sure the baffle is the full width of the inside
of the enclosure.
- If the distance from the back of the refrigerator to the
wall of the vehicle is more than one inch, install a baffle
[171] at the top of the intake vent between the back of the
refrigerator and the wall of the vehicle.
Part No.
617485
617484
620505
RO Height
7 1/4 in.
9 3/4 in.
6 3/16 in.
Art01634
14
Art01635
RO Width
18 in.
19 3/8 in.
17 13/16 in.
24
172
124
171
9
Installation Manual 5
11
10
9
25