Getting Started: Before First Use
Read the safety instructions found in this manual before plugging in and operating
the unit. Before using the unit for the first time, follow these steps:
1. Remove all packing materials and literature from within the product. Lift out
the removable cooking pot and remove any pieces of paper from under it.
Remove the plastic protection from the control panel and any stickers from
the lid or stainless steel housing.
2. Wash all removable parts in warm soapy water. Rinse and dry all parts
thoroughly. Wipe the stainless steel outer housing with a clean damp cloth.
NEVER submerge the stainless steel outer housing in water or any other
liquid. Only the removable cooking pot is dishwasher safe.
3. To clean the pressure regulator knob, gently push the pressure regulator knob
down and at the same time turn the p
knob counterclockwise past STEAM to CLEAN setting. Once the white dot on
CLEAN is aligned with the white dot on the base of the pressure regulator, you
can lift the pressure regulator up and off the lid. Look through the holes of the
pressure regulator to make sure there is nothing obstructing, and then clean
the pressure regulator knob with warm soapy water, allowing the water to run
through the pressure regulator to remove all particles.
4. To put the pressure regulator back onto the lid, simply align the CLEAN setting
with the white dot on the base, gently push down on the pressure regulator
and turn the knob clockwise until it slides back into place.
5. Make sure the silicone gasket is seated properly inside the lid or else the
cooker will not function properly.
6. After thorough drying, place the removable cooking pot back into the Multi-
cooker before cooking.
7
ressure regulator