Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
1)
Turn OFF the computer's power and remove the power cord from the wall
outlet before removing the front cover.
2)
Remove the blank panel from the front of the empty 5.25" bay slot.
3)
Install the slide rails on the drive if necessary.
(Please contact the store where the drive was purchase to obtain slide rails.)
4)
Insert the drive into the slot.
5)
When anchoring is required, refer to the computer's instruction manual.
• Please use screws measuring 5mm (3/16") or less for mounting. Using longer
screws may damage the drive.
• When the mounting screws are loose, the vibrations from a spinning disc may
generate a ripping noise. To prevent this noise, tighten the screws.
9
En
Publicité
Table des Matières
