Franklin Electric SPHE-S75 Guide D'utilisation page 4

SYMPTOM
Failure to pump: Pump not properly primed.
Speed too low.
Total head more than for which pump was intended.
Suction lift is too great.
Reduced Air pockets or leaks in suction line.
capacity and/or
Clogged impeller.
head:
Strainer too small or clogged.
InsufÄcient submergence of suction line.
Excessive suction lift.
Total head more than that for which the pump was
intended.
Excessively worn impeller.
Pump loses Air leaks in suction line.
prime:
Excessive lift and operating too near shut-off point.
Water level drops while pumping, uncovering suction
piping.
Mechanical Bent shaft and/or damaged bearings.
troubles and
Suction and/or discharge piping not properly supported
noise:
and anchored.
TROUBLESHOOTING
CAUSE
Make sure pump casing and suction line are full of water. See priming instructions.
All wiring, electrical connections and system grounding must comply with the National
Electrical Code (NEC) and with any local codes and ordinances. Employ a licensed
electrician. Check voltage at motor terminals and at meter when pump is operating. If
low, refer to wiring instructions or check with your power company. Check loose con-
nections.
A pump designed for higher head needed.
Locate pump closer to source of water. Make sure suction piping is large enough.
Check suction piping.
Remove and clean.
Use larger strainer or clean.
Add lengths of suction pipe to keep submerged end well below the water surface.
If caused by suction pipe friction, enlarge piping.
A pump designed for higher head is needed.
Order replacement parts using Repair Parts List.
Check suction piping.
Move pump nearer water level.
Check water supply. Add length of pipe to suction to keep submerged end under water.
Take motor to authorized motor repair shop.
See that all piping is supported to relieve strain on pump assembly.
WARNING - ELECTRICAL PRECAUTIONS
4
REMEDY