Replacing The Batteries; Cleaning And Maintenance - Philips SatinPerfect HP6576 Mode D'emploi

EnglisH
12

replacing the batteries

1 Open the battery and light compartment by turning the bottom anticlockwise with a
coin (Fig. 18).
2 Remove the old button batteries.
Keep the button batteries out of the reach of children and pets. Button batteries present a
potential choking hazard.
3 Insert the new button batteries with the negative side pointing forward into the battery and
light compartment (Fig. 19).
Note: The Smart Tweezers work on three alkaline button batteries type L736H or AG3 (dia. 7.8 x
3.4mm).
4 Screw the bottom back onto the battery and light compartment by turning it clockwise with
a coin (Fig. 20).

cleaning and maintenance

Note: Make sure the epilator is switched off and unplugged before you start to clean it.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
- Clean the appliance after each use to ensure better performance.
- Never rinse the appliance or the adapter under the tap (Fig. 21).
- Keep the appliance and the adapter dry (Fig. 22).
cleaning the attachments
1 Remove the attachment from the epilating head (Fig. 8).
2 Remove loose hairs from the attachments with the cleaning brush (Fig. 23).
3 Rinse the attachments with lukewarm water while turning them (Fig. 24).
4 Dry the attachments before you use or store them.
cleaning the epilating head of the epilator
1 Press the release knob (1) and remove the epilating head from the appliance (2) (Fig. 13).
2 Remove loose hairs with the cleaning brush (Fig. 25).
3 Rinse the epilating head under the tap for 5-10 seconds while turning the discs with your
thumb (Fig. 26).
Note: Never try to detach the epilating discs from the epilating head.
4 Shake the epilating head firmly (Fig. 27).
5 Dry the epilating head thoroughly with a tea towel.
Note: Make sure the epilating head is completely dry before you place it back onto the appliance.
6 To reattach the epilating head, place it on the appliance and press it onto the appliance until it
snaps home ('click') (Fig. 28).
cleaning the shave, trim and style attachment and the trimming comb
1 Remove the trimming comb, if attached, by pulling it off the shave, trim and style
attachment (Fig. 29).
4203.000.4617.1.indd 12 25-11-09 16:21