Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Overheat protection
The epilator has an integrated overheat protection, which prevents overheating of the appliance.
Note: To avoid overheating of the epilator, do not press the appliance too hard onto your skin. The epilator
works best when you move it over your skin without exerting any pressure.
1
If the overheat protection is activated, the appliance switches off automatically, the speed
setting indications and the charging light flash red.
2
Let the appliance cool down.
The lights stop flashing after 30 seconds.
,
3
When the appliance has cooled down, you can switch it on again. If the lights start to flash
red again, the appliance has not yet cooled down completely.
Overload protection
If you press the epilating head too hard onto your skin or when the rotating tweezers of the
epilating head get blocked (e.g. by clothes etc.), the appliance stops and the speed setting indications
start to flash red for 5 seconds.
1
Check if the rotating tweezers of the epilating head are blocked by turning the tweezers with
your thumb until you can remove whatever is blocking the rotating tweezers.
2
Switch on the appliance again.
Do not press the appliance too hard onto the skin.
Using the smart Tweezers
Your epilator comes with Smart Tweezers with integrated light for the easy removal of facial hair
such as your eyebrows. The Smart Tweezers are protected by a case with integrated mirror which
allows you to depilate wherever and whenever you want. The Smart Tweezers are supplied ready
for use with 3 button batteries in the battery compartment.
Using the tweezers
1
Clean your eyebrows with skin tonic or alcohol to prevent eyebrow hair from slipping away
between the tweezer arms.
2
Use a warm face cloth to soften the skin before tweezing. This makes hair removal easier.
3
Brush your eyebrows in the direction of hair growth.
4
Use an eye pencil to mark the desired shape of your eyebrows. Remove any hairs outside the
marked shape.
5
Switch on the light by pressing the on/off button once.
6
Always pull out the hair in the direction of hair growth.
Note: Pull out the hairs one by one.
Do not use the Smart Tweezers to remove hairs that grow out of moles.
Do not point the light of the Smart Tweezers directly at your or somebody else's eyes.
replacing the batteries
1
Open the battery and light compartment by turning the bottom anticlockwise with a
coin (Fig. 18).
4203.000.4682.1.indd 11
EnglisH
11
01-12-09 09:59
Publicité
Table des Matières
