First-Time Dvd/Vcr Setup 17 - Philips DVD750VR Mode D'emploi

H9421CD/DVD750(EN).pgs1-51.QX3 03.4.11 11:29 AM Page 17
Before turning on your DVD/VCR, make sure batteries are in the
remote control and the DVD/VCR and TV are connected correctly.
You cannot program channels if you are using a Cable Box or a
Satellite Receiver.
These menus may not appear if you have already turned
on the DVD/VCR.
1
Turn on the TV. Set it to channel 3 or 4 or its
AUDIO/VIDEO IN channel, depending on how you con-
nected the DVD/VCR to a TV.
2
Press VCR, then press STANDBY-ON. The green VCR
light will appear on the front of the DVD/VCR.The display
shown below will appear.
These menus may not appear if you have already turned on
the DVD/VCR.You may have turned on the DVD/VCR
before to find the Audio/Video In channel of the TV, for
example. If so, follow the steps on page 26 to set up chan-
nels and page 30 to select a language for the VCR menus.
3
Press o or p to select English, French, or Spanish as
the language for VCR on-screen displays and menus. Then,
press B.
AUTO SET UP
4
Press B to begin channel programming. AUTO
SETUP will flash on the TV screen during the channel
search.The DVD/VCR will memorize all available channels.
When channel programming is complete, the lowest avail-
able channel will appear on the TV.
These channels will be available when you want to watch
TV while in VCR mode.To put the DVD/VCR in VCR
mode, press VCR so the green VCR light appears. Use the
SKIP3/CHo and SKIP
rized channels.To select non-memorized channels, use the
Number buttons.

First-time DVD/VCR Setup 17

/CHp buttons to select memo-
1
Turn on the TV.
STANDBY-ON
SEARCH MODE DISPLAY
REPEAT REPEAT AUDIO
A-B
SUBTITLE ZOOM ANGLE SKIP / CH
RETURN TITLE CLEAR/RESET SLOW
VCR/TV
DVD VCR
SYSTEM DISC/VCR
MENU MENU
3-4
OK
STOP PLAY PAUSE
TIMER SET VCR Plus+ RECORD
SPEED
1 2 3
4 5 6 7
8 9 0 +10
Helpful Hints
• To skip this feature and play a tape
immediately, insert a tape with its
record tab removed.
• To skip step 3, press
DISC/VCR/MENU.VCR menus and
displays will be in English.
• If you try to program channels
when there is no antenna or Cable
TV signal connected to the ANT-IN
jack of the DVD/VCR, programming
will stop.AUTO SET UP will stop
flashing. Connect an antenna or
Cable TV signal to the DVD/VCR's
ANT-IN jack and press B again.
• Repeat this process if the power
fails.
• To stop the Channel Setup while
AUTO SET UP is flashing, press
DISC/VCR/MENU.
2