Automatic Operation Features - Philips DVD750VR Mode D'emploi

H9421CD/DVD750(EN).pgs1-51.QX3 03.4.11 11:30 AM Page 48

48 Automatic Operation Features

The following tape features are available in VCR mode. Press VCR so
the green VCR light is on, if necessary.
Automatic Playback
When you put a tape in the DVD/VCR, the power will come on. If
the tape's record tab is missing, playback will begin.
If a timer recording is set and the RECORD TIMER light is flashing,
the power will not come on automatically when you insert a tape
with the record tab intact.
If a timer recording is set and the RECORD TIMER light is flashing,
the DVD/VCR will eject the tape if the record tab is missing.
Automatic Rewind, Eject
When a tape is played, fast forwarded, or recorded to its end, the
tape will rewind to the beginning, stop, and eject.
This feature does not operate if AUTO REPEAT is ON. Details are
on page 44.
Tape Eject
A tape can be ejected with the DVD/VCR power on or off (but
the DVD/VCR must be plugged in).
If a timer recording is set and the RECORD TIMER light is on,
pressing STOP/EJECT A will turn on the DVD/VCR and/or cancel
the timer recording.The RECORD TIMER light will turn off. Press
STOP/EJECT A again to remove the tape. Remember to insert a
tape and press TIMER SET to reset the timer recording.
Automatic Tracking Adjustment
The VCR adjusts tracking automatically to give you the best possible
picture quality.With some recordings, however, you may get a better
picture using manual tracking (see below).
Manual Tracking
To manually adjust the tracking during normal playback and slow
motion playback of a videotape, press SKIP3/CHo or SKIP
/CHp on the remote.
Tracking will return to Automatic Tracking when you press STOP
C or insert a tape.
Furthermore, you can press SKIP3/CHo or SKIP /CHp to
remove vertical jitter in a Still picture.
Before
Tracking
Adjustment
After
Tracking
Adjustment