Helpful Hints - Philips DVD750VR Mode D'emploi

H9421CD/DVD750(EN).pgs1-51.QX3 03.4.11 11:29 AM Page 10
10 Hookups (cont'd)
This connection will let you use the features of both the VCR and the DVD Player.
1
Cable
Signal
Connections
1
Connect a Cable TV or Satellite signal to the
DVD/VCR's ANT -IN (Antenna In) jack.
2
Use an RF coaxial cable (as the one supplied) to con-
nect the ANT -OUT (Antenna Out) jack on the
DVD/VCR to the IN jack on the Cable Box/Satellite
Receiver.
3
Use a second RF coaxial cable to connect the OUT
jack on the Cable Box/Satellite Receiver to the
ANTENNA IN jack on the TV.
Remember...
There are two ways to connect your Cable Box/Satellite Receiver to
the DVD/VCR.With the connection on this page:
You may watch one channel while recording another. Follow these
steps:
1) Put the Cable Box/Satellite Receiver on the same channel as
the DVD/VCR's output channel (03 or 04).The DVD/VCR's output
channel is channel 3 when the DVD/VCR is new.To alternate it
between 3 and 4, press and hold the (VCR) PLAY B button on the
front of the DVD/VCR for 3-5 seconds during tape playback. For
details, see step 4 on page eight. Set the TV to the Cable
Box/Satellite Receiver output channel (03 or 04).
2) Press VCR to put the DVD/VCR in VCR mode.The green VCR
light will appear on the front of the DVD/VCR.
3) Press VCR/TV on the remote to choose VCR position.
4) Press SKIP3/CHo or SKIP
want to record at the DVD/VCR. Press RECORD or RECORD to
start the recording.
5) Press VCR/TV on the remote once to put the DVD/VCR in TV
position.
6) Select the channel you want to watch at the Cable
Box/Satellite Receiver.
When you play a tape or Disc, make sure the Cable Box/Satellite
Receiver is set to the DVD/VCR's output channel (03 or 04).
Set the TV to the Cable Box/Satellite Receiver output channel (03
or 04).
DVD/VCR to Cable Box or Satellite Receiver and TV
Using only basic RF coaxial cables
DVD/VCR
DVD/VCR VCR
AUDIO OUT AUDIO IN
ANT-IN
L L
R R
ANT-OUT VIDEO OUT VIDEO IN
RF coaxial cable
/CHp to select the channel you
2
Cable Box/Satellite Receiver
DVD
DIGITAL
S-VIDEO COMPONENT AUDIO
OUT VIDEO OUT OUT
AUDIO OUT
Y
C B L
COAXIAL
IN
C R
R
OU T
RF coaxial cable
• When you play a tape, make sure
• If your Cable Box or Satellite
7 5
A N T
/
C A B
L E
3
TV's ANTENNA
IN Jack

Helpful Hints

the Cable Box/Satellite Receiver is
set to the same channel as the RF
output channel of the DVD/VCR
(03 or 04). Set the TV to the
Cable Box/Satellite Receiver output
channel (03 or 04).
Receiver has Audio and Video Out
jacks, use audio and video cables
to connect them to the VCR
AUDIO IN and VIDEO IN jacks on
the rear of the DVD/VCR.You will
not need the RF coaxial cable con-
nection between the Cable
Box/Satellite Receiver and the
DVD/VCR as described at step 2.