Assembling The Guide Bar And Saw Chain - Oregon CS1400-091 Manuel D'instructions Original

Place the chainsaw on a firm, flat surface so
that the oil cap is on top (Fig 6)
FIG. 6
• Clean any debris from the cap area
• Remove the cap
• Carefully pour the bar and chain oil into the
reservoir
• Replace the cap and make sure oil is visible in
the reservoir
PRIMING THE OILER
WARNING: To reduce the risk of injury,
never run the chainsaw without the side
cover.
CAUTION: Keep hands, clothing, and
hair away from the drive sprocket when
priming the oiler.
If this is the first time filling the bar and chain
oil reservoir, or if the chainsaw has been stored
for a long period of time without use, prime the
oiler
Wear gloves
• Unplug the chainsaw
• Loosen the side cover release knob slightly,
but do not remove the side cover
• Loosen the chain tensioning ring (turn it
counterclockwise) as far as it will go
• Loosen the side cover release knob and
remove the side cover
• Remove the guide bar and saw chain
• Plug in the chainsaw
• Install the side cover, then lightly tighten the
side cover release knob
• Run the chainsaw for about two minutes
14
Preparing for Use
• Unplug the chainsaw, remove the side cover
and check for oil on the bar pad (Fig 7)
FIG. 7
• If no oil is present on the bar pad, replace the
side cover and run for another 30 seconds
• When oil begins to seep from the hole, unplug
the chainsaw and replace the bar and chain as
described in "Maintaining the Guide Bar"
If oil is not visible in the reservoir, additional bar
and chain oil is necessary
Assembling the Guide Bar and
Saw Chain
WARNING: An electric power tool
that is plugged in can start accidentally.
Unplug the chainsaw before preparing for
use or performing maintenance.
Wear gloves
• Unplug the chainsaw
• Loosen the side cover release knob by turning
it counter clockwise, then remove the side
cover (Fig 8)
FIG. 8
Chainsaw Model CS1400-091