Krups EA90 Serie Mode D'emploi page 239

KRUPS
SERIE EA90
n
The steam tube moves down.
n
You can thus clean it properly with a damp cloth (you can use a little
washing-up liquid, but rinse it thoroughly). The steam tube cannot be
6
dismantled.
n
Press the "OK" button. The steam tube moves up so that the nozzle tip
and the nozzle can be refitted.
n
Re-screw the nozzle with the tip onto the steam tube.
n
Press the "OK" button.
n
The steam nozzle assembly moves up and stops above the cleaning
7
container.
n
Cleaning the steam nozzle cleaning container (11).
n
Press YES to the question: "Do you want to clean your cleaning container?"
if you want to clean it.
n
Press the top of the container to remove it. Clean it under running water.
n
To put the container back, first position the lower part and then press the
upper part: you should hear a "click".
n
Press the "OK" button.
8
n
Replace the two drip trays (see visuals p. 13).
n
The manual steam nozzle cleaning cycle is finished.
9
n
Press OK to confirm and quit.
!
Caution:
The manual cleaning of the nozzle and the cleaning container must be carried out in this
sequence: If not, you risk damage to the steam nozzle assembly, malfunction or breakage.
38