Krups EA90 Serie Mode D'emploi page 230

n
Selection of volume and selection of number of cups (single or
one after the other).
n
The screen displays the last volume requested. You can modify this
2
volume using the arrows on the left and right of the indicated value.
n
Your appliance allows you to prepare one or two cups after the other.
n
Place your cup under the coffee nozzles.
n
The cup must be placed close to the cleaning container.
n
Caution: use a cup that matches the volume of the recipe. The
maximum height of the cup is defined by the coffee nozzles; do not
tilt the cup to place it under the coffee nozzles.
3
n
Caution: Do not press the cleaning container (11) with the cup;
otherwise, it might break off.
n
Press OK. The steam nozzle then comes out of its cleaning
container to stop just above your cup.
n
You will need to modify the steam nozzle position using the + and -
symbols according to your convenience. If the steam nozzle is too high
from the bottom of the cup, there is a risk of splashing. Caution: The
4
nozzle must not touch the bottom of the cup either.
n
Press the OK button on the touch screen.
n
Dispensing hot water through the steam nozzle.
n
If necessary, the machine goes into preheating mode, then begins to
dispense hot water.
n
You can modify the volume of your preparation using the arrows on
the left and right of the indicated value.
n
Press "Stop" to stop the recipe.
5
!
Important:
The production of hot water does not stop immediately after you press the
(it takes 3 to 5 seconds to stop). Press the button sufficiently early to avoid overflows.
ENGLISH
"Stop" button
29