Krups EA90 Serie Mode D'emploi page 215

KRUPS
SERIE EA90
n
Emptying the used coffee collector
Open the left door.
!
Caution:
Do not wash it in the dishwasher.
At each stage check the messages on the touch screen
n
Empty the drip tray
Remove the drip tray.
Your machine has a drip tray (6).
The drip tray collects waste water and is equipped with an overflow detection sensor.
n
When it needs to be emptied, the request will be made on the screen.
n
The cover of this tray is necessary to avoid excessive condensation and water spills.
n
!
Caution:
The cover and the grid can fall when you empty the drip tray.
If the tray is dirty, clean it under running water. If the metal contacts are dirty, clean by scrubbing
n
them under water. Wipe the metal contacts dry before putting them back in the machine.
The drip trays will be separated when you empty them. Avoid spilling water as much as possible on
n
the metal contacts located at the end of the drip tray.
If the machine asks you to empty the drip tray when it is empty, check whether the metal contacts
n
at the back of the drip tray are clean and thoroughly dry.
n
Adjusting the coffee nozzle height
14
Remove the used coffee collector by
pulling it towards you.
Empty the used grounds.
Replace the used coffee collector.
Empty the drip tray.
Wipe the metal contacts.
Open the left door (15). Remove the used coffee
n
collector (5). Empty and clean it before putting it
back in place.
Replace the drip tray.
Your machine is supplied with two cups only which can be used
for cappuccino or a caffe latte.