Table des Matières
Publicité
Drive Mechanism
Apply grease
(part no. 75988 061 7800)
Fig. 8.34
Apply grease (part no. 75988 061 7800)
to the bottom of the clamp
Fig. 8.35
8.12 R/P Head Assy (Pos. 50200)
– Undo the screw (Pos. 50210), press the R/P head assy
(Pos. 50200) in the direction of the arrow as shown in Fig. 8.36 and
remove it upwards.
Note: Align the hole U of the R/P head assy (Pos. 50200) and pin
V on the mechanism chassis.
Subsequently, adjust the tape path and tracking position
(X value, refer to point 9. „Adjustments").
5 - 28
70400 Cassette lid opener
50200 R/P Head assy
50210
Screw
Fig. 8.36
8.13 Tape Drum
– Undo two screws (Pos. 30000), remove the motor stator
(Pos. 22000) and the tape drum earth spring (Pos. 11600,
Fig. 8.37).
– When turning the mechanism upside down now, the carbon chip
(Pos. 11500) will fall out (Fig. 8.37).
– Undo two screws (Pos. 30000) and remove the motor rotor
(Pos. 21000, Fig. 8.37).
– Undo the three screws (Pos. 10400) at the bottom of the mechanism
and take the complete tape drum (Pos. 11000) out (Fig. 8.39).
30000 Screws
30000
Screws
11600
Earth spring,
tape drum
11500 Carbon
chip, tape drum
Fig. 8.37
GV 29 EURO, GV 9300 EURO
U
Hole
V
Pin
Flexible cable
22000 Motor stator
21000
Motor rotor
11000
Tape drum
GRUNDIG Service
Publicité
Table des Matières
