Table des Matières
Publicité
SETTINGS
____________________________________________________________________________________
Channel programming with the automatic tuning
system ATS euro plus
The recorder has a built-in receiver. It can therefore receive and record television
programmes independently of the TV set.
For this, you must programme the TV channels on the video recorder.
When carrying out this function, the time is automatically updated, provided a TV
programme with teletext is received on programme position 1.
88 programme positions are available which can be assigned as desired to TV
channels received via the aerial or the cable system.
Preparation
AUTO INSTALLATION
Switch the TV set on.
PRESS OK KEY TO START.
Select the »AV« programme position for video playback on the TV set.
AUTOMATISCHE EINSTELLUNG
ZUM START DIE OK TASTE
DRÜCKEN.
Programming
1
D
D
Press the »
« button.
OK :ENTER
INFO:EXIT
– The »AUTO INSTALLATION« table appears on the picture screen of the
TV set.
LANGUAGE
Help:
ENGLISH
DENMARK
If the »AUTO INSTALLATION« table does not appear, press the» « and » «
DEUTSCH
SVENSKA
buttons on the video recorder at the same time until the table appears.
FRANÇAIS
FINLAND
ITALIANO
ESPANOL
NEDERLANDS PORTUGUESE
2
Initiate programming with the » OK« button.
– The »LANGUAGE« table appears on the picture screen.
‹›
: SELECT
OK :ENTER
INFO:EXIT
3
Use the »
C D
C
D F
F E
4
Press the » OK« button to start the automatic tuning system.
– »AUTO« flashes in the video recorder's display.
AUTOMATIC SORTING
PLEASE WAIT
– The recorder searches all channel numbers for TV stations, then sorts and
stores them. This can take several minutes.
. – – – – – – – – – – – – – – – – – –
– When the search is completed, the message »AUTO-SETUP COMPLETED!«
and the number of the output channel appear on the picture screen.
»OK« appears in the video recorder's display.
INFO:EXIT
Note:
If the video recorder and the TV set are not connected with a EURO-AV cable,
you must repeat the setting on page 11 and tune the TV set to the channel
AUTO-SETUP COMPLETED!
(e.g.» C H 2 7 «) indicated in the table.
VCR OUTPUT CHANNEL
WILL CHANGE TO CH 27.
OK :ENTER
INFO:EXIT
« buttons to select the desired language.
E
SETTINGS
____________________________________________________________________________________
5
Press the »OK« button.
CLOCK
– The » CLOCK« table appears on the picture screen.
TIME DATE
YEAR
Check the time and the date.
9:03 05/02
99
*
Note:
ADJUST
:AUTO
- :OFF
*
If the time has not been updated automatically, it must be set manually, see
‹›
chapter "Setting the Time and Date" on page 34.
:SELECT
:CHANGE
OK :ENTER
INFO:EXIT
6
Press the »OK« button to end the setting.
Note:
Further settings such as manual channel search, changing the order of the
channels at a later date, clearing TV channels from the station table, or
assigning station names, are described from page 30 on.
Publicité
Table des Matières
