Replacing Parts Of The Drive Mechanism - Grundig GV 29 EURO Manuel De Service

GV 29 EURO, GV 9300 EURO

8. Replacing Parts of the Drive Mechanism

Note: The replacement of the mechanical parts described below is
based on the assumption that the drive mechanism is already
dismantled (see page 1-19).
The drive mechanism is to be built in exclusively in the Eject
position. For this, position all gear wheels, levers and the mode
switch S8001 as they are in Eject mode (Fig. 8.1 and 8.2).
Fig. 8.1
A
Hook
C
Lever
60900
Fig. 8.3
GRUNDIG Service
Screw 6073
Hole
C
Hole
Hole
B
Align the positions
Fig. 8.2
Mode switch
8.1 Removing the Cassette Mechanism (Pos. 0090)
– Undo 2 screws (Pos. 6073, Fig. 8.3).
– Lift the back of the cassette mechanism (Pos. 0090) by a small
amount, slide it backwards and remove it.
Note: When reassembling the cassette mechanism (Pos. 0090)
the lever (Pos. 60900) must be pressed towards the front.
The cassette mechanism (Pos. 0090) is positioned correctly
when the two hooks A and the dowels B engage with the
holes C
Cassette mechanism
0090
Dowels
C
Hole
C C
Holes
Drive Mechanism
6073 Screw
Lever, lid opener
040E
B
Dowels
A
Hook
5 - 21