Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
I
nstallation Instructions:
1.)
Remove the luggage compartment cover, the trim from the centre section of the rear panel, the left
and right side panels in the luggage compartment, the jack (with bracket), the spare wheel and the
battery (if located in the luggage compartment).
2.)
Remove the rear bumper.
3.)
Remove the rear silencer, including heat shield.
4.)
From below, predrill Ø 13-mm holes in the frame side members at positions "a" and "b" and then
drill them out to Ø 18 mm and deburr the edges. The positions for drilling have been marked with a
prick punch.
5.)
Drill an approx. Ø 50 mm hole in the centre of the body - for the protruding stub on the top of CBB
"1" - and deburr the holes. To determine the position for the hole, hold the CBB against the floor pan
and mark the position for drilling. (Tip: Predrill the hole to a diameter of 6 mm and then enlarge the
hole to 60 mm using e.g. a hole saw.)
6.)
NOTE: Only applies to support "6" and reinforcement "7" (left)
a)
For vehicles up to veh. ID end no.:
and
For vehicles up to veh. ID end no.:
Use support "6" (left), long version and reinforcement "7" (left), long version. (If not supplied with
the scope of delivery, please repeat separately! Order No.: 913 082 650 002).
Insert support "6" and reinforcement "7" into the left frame side member. At position "f", remove
the rubber grommet fitted in the vehicle, insert the hexagon bolts together with the washers at
positions "f" and "g" and then bolt the support and plate loosely to the vehicle.
Align support "6" and reinforcement "7" in the left frame side member and mark positions "d" on
the vehicle body. Drill two Ø 15 mm holes and deburr them.
Insert fishplate "5" at positions "d" and bolt loosely using M 10 locknuts.
a)
For vehicles as of veh. ID end no.:
and
For vehicles as of veh. ID end no.:
Use support "6" (left), short version and reinforcement "7" (left), short version (both parts belong
to scope of delivery).
Insert support "6" and reinforcement "7" into the left-hand frame side member. Drill a Ø 15-mm
hole at position "h" and deburr the edges. The position on the vehicle has been marked with a prick
punch (see also sketch X).
Insert a bolt and washer at positions "h" and "f" and bolt them loosely to the frame side
member.
14
....1F 020 797
....1A 032 469
....1F 020 798
....1A 032 470
Publicité
Table des Matières
