Rear Exit Shield (For Rear Vent Only) - Napoleon Ascent 36-1 Manuel D'installation Et D'opération

venting requirements
EN
2.11

rear exit shield (for rear vent only)

Remove the safety barrier assembly and door from the appliance (see "safety barrier & door
A.
removal / installation" section).
Loosen the two screws that secure the exhaust plate, and slide the shield in place by sliding its
B.
slotted openings behind the screwheads. Tighten the two previously loosened screws (Fig. 1).
Reinstall the door and safety barrier assembly on the appliance (see "safety barrier & door
C.
removal / installation" section).
note:
This shield is used to block the view through the venting to the outdoors.
24
W415-2835 / A / 12.09.20
Fig. 1