Electrical Connection Requirements; Electrical Connection Clearance; Gas Connection Requirements; Gas Supply Location - Amana ARGS7650 Serie Mode D'emploi

Electrical Connection Requirements

WARNING
To avoid the risk of serious electrical shock or
property damage, do not cut or remove the third
(ground) prong from the power plug. A 3-wire
grounded conductor system must be used. Relying
on the flexible connector, hard piping or any other part
of the gas supply line as a ground may cause fire,
electrical shock and/or erratic control operation.
Range must be electrically grounded in accordance with
local codes or in the absence of local codes, with the
National Electrical Code, ANSI/NFPA No. 70-Latest
Edition. In Canada, electrical connections are to made in
accordance with CSA C22.1 Canadian Electrical Code.
Use a dedicated 120 volt, 60 hertz, 3-prong receptacle
protected by a 15 amp circuit breaker or time delay fuse.
A qualified electrician should confirm the outlet is
properly grounded.
If a 2-prong outlet is encountered, range owner must
replace outlet before using range. Do not cut off cord,
use plug adapter, remove grounding plug, or use
extension cord.

Electrical Connection Clearance

Electrical connection must be located in the shaded area
shown in Figure below. Electrical connection must not
interfere with gas connection.
A—2 inches (Both sides)
B—19½ inches
C—12 inches
D—6 inches
A
D
B
C

Gas Connection Requirements

Before connecting this appliance to the gas supply piping
system, confirm installation meets the requirements of local
codes, or in the absence of local codes, with the National
Fuel Gas Code, ANSI Z223.1-Latest Edition. In Canada
installation must conform with local codes or the current
Natural Gas Installation Code CAN/CGA-B149.1.

Gas Supply Location

Gas supply must be located in the shaded area shown
below. Gas connection must not interfere with the
electrical connection.
A
B
B
A
A—18 inches
B—12 inches
C—3½ inches
D—6 inches
8
C
D