Adjusting Oven Temperature; Common Questions; Service Tones And Codes - Amana ARGS7650 Serie Mode D'emploi

Adjusting Oven Temperature

Oven temperature has been factory calibrated and tested.
If oven consistently over or under cooks food, adjust
thermostat. Oven tempurature can be increased or
decreased 35°F. To avoid over adjusting oven, move
temperature 5°F each time.
1. Push BAKE pad.
2. Press pad until an oven temperature greater than
500°F shows in display.
3. Immediately push and hold, approximately
5 seconds, BAKE button until "00" appears in
display.
4. Press or pad knob to adjust oven
temperature.
• To increase oven temperature (for a hotter oven),
Press or pad until a positive number
appears in display.
• To decrease oven temperature (for a cooler oven),
Press or pad until a negative number
appears in display.
5. Press OVEN CANCEL pad to save adjustment.
• Setting is saved if power fails or is disconnected.

Common Questions

Should a fan turn on while oven is warm?
• A fan can come on at any time to cool internal
components.
Should the oven maintain a constant temperature on an
oven thermometer?
• To maintain a temperature for baking, the oven cycles
on and off. The temperature may vary up to 25°F higher
or lower than the oven temperature set on the control.
Is there a problem if the oven smokes the first few times
it is turned on?
• Some minor smoking is normal when using oven first
few times.
Should there be an odor or smoke while self-cleaning the
oven?
• There may be some smoke and odor during cleaning
cycles. If there is excessive smoke or odor, too much
soil remains in the bottom of the oven. If the oven
smokes excessively, turn off the oven, wait for the oven
to cool and wipe away the excess soil. Reset the clean
cycle.

Service Tones and Codes

Electronic range control has a self-diagnostic system.
Self-diagnostic system sounds a series of short, rapid
beeps and shows a "F-code" in display when there is a
problem. When electronic range control signals a
problem, follow steps listed below.
1. Record "F-code" shown.
• F1—pad malfunction
• F2—high oven temperature
• F3—temperature sensor malfunction
• F4—temperature circuit malfunction
• F5—control malfunction
• F7—door lock malfunction
• F9—door lock or oven door not completely closed
2. Press TIMER ON/OFF pad or disconnect electrical
supply.
• Disconnecting electrical supply eliminates
"F-code". If failure continues, contact an authorized
servicer.
3. Contact an authorized servicer to check range.
29