Anti-Tip Bracket Installation; Level Range; Removal And Replacement Of Range - Amana ARGS7650 Serie Mode D'emploi

Anti-tip Bracket Installation

To reduce risk of range tipping, secure range with a
properly installed anti-tip bracket.
1. Remove storage drawer from range.
• See "Removing Storage Drawer" section.
2. Unscrew leveling legs so when range is moved into
position range top clears counter top.
• Left or right rear leveling leg must extend at least ¼
inch to engage bracket.
• Anti-tip bracket can be installed on either right or
left rear leveling leg.
3. Move range to where it will be installed.
4. Position anti-tip bracket.
• With range in position, reach through storage
drawer opening and slide anti-tip bracket on either
left or right rear leveling leg. Slide leg into V-
shaped notch in bracket.
5. Mark location of side and front of anti-tip bracket on
floor.
6. Remove anti-tip bracket and range from opening.
7. Position anti-tip bracket according to lines marked on
floor.
8. Mark 2 hole locations in anti-tip bracket.
9. Drill 2 holes.
• If drilling into wood, use a
• If drilling into concrete, use a
bit and insert plastic anchors.
10. Secure bracket to floor using screws supplied.
11. Slide range into position.
• See "Level Range" section of manual.
12. Confirm anti-tip bracket is engaged with range
leveling leg and replace storage drawer.
or
3
/ inch drill bit.
32
3
/ inch masonry drill
16

Level Range

Carefully level range using legs provided. Range must be
level to cook and bake uniformly.
CAUTION
To avoid damaging oven door, do not lift or move range
by oven door handle. Glass can break.
• Place a level on top oven rack or on top of range when
leveling.
• Leveling legs must be extended a minimum of
¼ inch to engage anti-tip bracket.
1. Extend leveling legs so when range is moved into
position range top clears counter top.
2. Slide range to where it will be installed.
• Position range so rear leveling legs do not engage
anti-tip bracket.
3. Turn leveling legs to level range.
• Turn legs clockwise to decrease range height or
counter clockwise to increase range height.
• Adjust rear leveling leg that engages anti-tip
bracket first. Leveling leg can not be adjusted while
in bracket. After adjusting leg that engages anti-tip
bracket, slide range until leg engages bracket, and
adjust other legs.
4. Replace storage drawer.

Removal and Replacement of Range

1. Disconnect power to range.
2. Slide range forward.
3. Unplug range cord and place range aside.
4. Remove anti-tip bracket.
5. Install anti-tip bracket into new location using
instructions provided with bracket or see "Anti-tip
Bracket Installation" section.
6. To reinstall range, follow instructions in "Installation"
section.
14