Removing Storage Drawer; Replacing Burner Caps; Replacing Drip Pans; Before Calling For Service - Amana ARGS7650 Serie Mode D'emploi

Removing Storage Drawer

1. Slide drawer out until it stops.
2. Grasp drawer sides near back of drawer.
3. Lift up and out.
• Reverse to reinstall.

Replacing Burner Caps

To replace burner caps after cleaning, make sure cap is
dry, properly aligned, and leveled. Pegs in the burner body
fit into recess in underside of burner cap. Burner cap must
be correctly seated on burner body for proper operation of
burner. Burner will not burn properly if wrong size burner
cap is placed on wrong size burner body. Check for
ignition after placement.
Burner cap

Replacing Drip Pans

Drip pans may be removed for cleaning. When replacing
drip pans after cleaning, holes in drip pan must match
properly with burners. Drip pans will fit properly only one
way.

Before Calling for Service

Problem
Oven light not
working
Oven not
heating
Oven door will
not open
Range top
gets warm
during use
Oven
temperature is
not accurate
Oven cycles
on and off
Self-clean
cycle not
working
Surface
Burner body
burner not
lighting
28
Check
Check for loose bulb.
Check for burned out bulb; replace
with 40 watt appliance bulb.
Turn on surface burners to confirm
gas is supplied to range. Confirm
range is plugged in and circuit
breaker is not tripped.
Wait for oven to cool. Door latch will
release automatically.
This is normal.
Store bought oven thermometers do
not measure oven temperature
accurately. An accurate digital
thermometer is necessary to calibrate
oven.
Check for blocked heat vents.
Aluminum foil alters oven
temperature.
Confirm correct utensil is used for
cooking.
This is normal when baking or
roasting.
Confirm oven door is closed.
Confirm cap is properly placed. Verify
drip pan is properly positioned in pan
section. See "Care and Cleaning"
section.