Adjusting Surface Burner Low Flame Size; Adjusting Oven Burner Flame; Broiler Flame - Amana ARGS7650 Serie Mode D'emploi

Adjusting Surface Burner Low Flame Size

1. Push and turn burner control knob to "LITE" position.
• Burner sparks until turned from "LITE".
2. Set burner control knob to low setting.
3. Remove burner control knob.
4. While holding valve stem stationary, turn screw in
center of burner control stem until flame is adjusted.
• Use small standard screwdriver.
5. Replace burner control knob.
6. Turn surface burner control on and off to test burner
flame.
7. If flame is adjusted too low, flame may be easily
extinguished. Burner can be extinguished by drafts,
door opening or closing, heating and cooling vents,
ceiling fans, etc.

Adjusting Oven Burner Flame

Properly adjusted oven burner flames are clean and blue
with a distinct inner cone approximately ½ inch long.
• If burner flame is blowing or noisy, reduce airflow to
burner.
• If burner flame is yellow and does not hold its shape,
increase airflow to burner.
WARNING
To avoid electric shock that can cause personal injury
or death, disconnect main electrical supply to range
before servicing.
1. Remove storage drawer.
• See "Removing Storage Drawer" section.
2. Locate and remove 2 screws attaching Z-shaped
cover plate.
• Cover plate located in center, rear of storage drawer
cavity.
• Removing cover plate exposes oven burner orifice
and air shutter.
A—Air shutter lock screw
B—Orifice hood
C—Air shutter
3. Loosen air shutter lock screw and open or close air
shutter.
• Tighten air shutter lock screw after adjusting.
4. Replace cover plate and storage drawer.

Broiler Flame

Broiler flame should appear hazy or fuzzy. Haze should
3
be approximately / inch thick. Because broiler has a
8
fixed orifice it can not be adjusted. Broiler does not have
an air shutter.
16