Pando ORPAN E-225 Guide D'installation page 15

FIRST POWER UP AND STARTING UP OF THE HOOD
Once the hood has been installed and it has been connected to the power supply, connect the
main switch of the connection box and synchronise the remote control, the process of which is
detailed below:
We open the panel covering the filter, extracting the filter and we see the connections. On the
side of the box or just above is the ignition switch and we start up the hood by putting it into the
ON position. (See drawings of position of the connection box and switch in the ON POSITION,
depending on model or versions)
–
IMPORTANT!!! (Once started up, follow the instructions for synchronisation of the remote control)
* Once the switch is ON, the light key on the remote control must be pressed or held down
within 15 seconds, towards the hood, and then the hood light should turn on, which will
that the synchronisation has been completed successfully.
OFF
* The synchronisation of the remote control with the hood can be lost if the synchronisation
process is not properly carried out within 15 seconds after start up, by power outages
or electrical variations of the network, causing the hood to not respond to the orders of
the remote control, and it will need to be synchronised once again.
* Remote control Synchronisation with hood:
1.- Disconnect differential from the house or circuit box switch that powers the hood (OFF).
2.- Reconnect differential from the house or circuit box switch that powers the hood (ON).
3.- IMPORTANT : Once step 2 has been carried out within 15 seconds, with the remote control
toward the hood, press or hold down the * LIGHT key on the control.
4.- The main hood lights will turn on, meaning that the remote control code has already
been registered by the hood and is already synchronised.
* REMOTE CONTROL SYNCHRONISING
ON
Light key
Light key
confirm
: OFF
: ON