Easy Maintenance & Cleaning - Jay J3 CUSHION Instructions Pour L'utilisation

E N G L I S H E N G L I S H
EASY MAINTENANCE & CLEANING
Monthly cleaning and regular maintenance may help extend the
life of your cushion. During cleaning, component inspection is
recommended.
Check the cover for tears and excessive wear and replace if
ripped, torn, or otherwise not fully functional. Inspect the fluid
pad for punctures or any other abnormalities.
Check the foam base to ensure foam consistency. While
checking the fluid pad if you ever feel the fluid is firmer in one
area, simply knead the fluid back to its original consistency and/
or call your local authorized supplier.
To clean cover
1.
Remove the cover from the foam base and turn inside out.
2. Machine wash in warm water and drip or tumble dry on
low heat.
No ironing required.
CAUTION– – DO NOT DRY CLEAN COVERS OR USE INDUSTRIAL
WASHERS AND DRYERS TO CLEAN COVER. DO NOT
STEAM AUTOCLAVE. DO NOT BLEACH.
To refit cover after washing, re-setup the cover on the foam
base. Ensure the back of the cover matches up to the back of
the foam base.
NOTE: If utilized in an institutional setting, write the resident's name with
a permanent marker on the content label of the covers. This will
help to ensure the return of the covers after washing.
Use only Jay designed covers on Jay cushions. The cover is
an important part of allowing the immersion into the fluid insert
which redistributes the pressure. Changing the cover will alter
this design and its efficacy.
To clean foam base, PLA reducer ring and
positioning components
Remove the cover, fluid pad, and PLA reducer ring (if applicable)
from the foam base. Wipe lightly with a damp cloth. Do not use
soap. Do not submerge in water. Wipe off with a clean cloth. Let
it completely air-dry before reassembly.
NOTE: Avoid submersion of the foam base in water.
Re-setup the cover over foam base. Ensure the back of the
cover matches up to the back of the foam base.
To clean fluid pad and fluid inserts (if applicable)
Remove the cover from the foam base. Remove fluid pad from its
foam base and wipe with warm water and soap. Rinse with a
clean, damp cloth. Then wipe dry with a clean cloth.
CAUT T I I O O N N – – NEVER SUBMERGE THE FLUID PAD IN ANY LIQUID.
C C A A U U T T I I O O N N – – AVOID HARSH CLEANING OR ROUGH HANDLING AS THIS
MAY LEAD TO A DEGRADATION OF THE FLUID INSERT.
If at any time, the cover, Pelvic Loading Ring, Foam base, fluid
insert or any other component appears to be wearing or you
notice a degradation in the texture, contact your supplier/
Sunrise for evaluation and further instructions.
To clean the Air Insert (if applicable), Reference the Air
Insert Owner's Manual Supplement for proper cleaning
instructions.
109578 Rev. C
M A I N T E NA N C E A N D C L E A N I N G
(Cushion Cover) Laundry Care Symbols
REASSEMBLING THE JAY J3 CUSHION
AFTER CLEANING
Follow cleaning and maintenance instructions as described in
"Easy maintenance and cleaning" then reassemble as follows.
Insert the JAY Fluid or
sure that all Velcro strip locations are aligned. A
®
misalignment or creation of an edge could cause an
unwanted pressure point which could lead to injury.
Insert the foam base into the outer cover. Ensure that the zipper
is at the rear of the foam base (the part number tag should be
to the rear of the foam base) where the pelvic loading area is
located.
Supplemental
fluid pads
(Field Variable
version only)
PLA reducer
(if applicable)
4
Machine wash in warm water
(60° C)
Only non-chlorine bleach,
when needed
Drip dry
Do not iron
Do not dry clean
WARNING
on the foam base making
Air Insert
Fluid insert
Air Insert
Foam base