Philips Saeco Xelsis RI9946/47 Mode D'emploi page 48

40
maintenanCe
4
EMPTY DRIP TRAY PLACED
UNDER THE BREW UNIT
OK
Empty the drip tray placed under the
dispensing spout (page 44 - fig. 2) and
then replace it on the machine .
Then, press the "OK" button.
7
DESCALING CYCLE
STEP 1/2
DESCALING CYCLE...
PAUSE
The descaling cycle is activated .
The bar shows the cycle's progress.
A default amount of water is needed for the rinsing step. This allows performing an ideal rinse cycle to ensure the best conditions to
brew products. The message about filling the tank for the rinse cycle is normal, as it is part of the procedure.
10
RINSE THE WATER TANK AND
FILL WITH FRESH WATER
OK
Rinse the water tank and refill it with
fresh drinking water.
Then, press the "OK" button.
5
FILL THE CARAFE HALFWAY
WITH FRESH WATER AND INSERT
IT IN BREWING POSITION
OK
Fill half the carafe with fresh water
(page 42 - fig. 7).
Insert the carafe and place it in the
brewing position. Then, press the "OK"
button .
8
DESCALING CYCLE
STEP 1/2
DESCALING CYCLE...
PAUSE
If the containers need to be emptied,
press the "PAUSE" button.
Then, press the "START" button when the
container has been emptied and replaced .
11
EMPTY DRIP TRAY PLACED
UNDER THE BREW UNIT
OK
Empty the drip tray placed under the
dispensing spout (page 44 - fig. 2) and
replace it back onto the machine .
Then, press the "OK" button.
6
PLACE A CONTAINER UNDER HOT
WATER & CARAFE DISP. SPOUTS
OK
Place a container under the dispensing
spout and a container under the hot
water wand.
Then, press the "OK" button.
9
RINSE THE WATER TANK AND
FILL WITH FRESH WATER
At the end of the first step, when the
descaling solution is finished, the
machine will require a tank rinse.
12
FILL THE MILK CARAFE
WITH FRESH WATER
OK
Completely empty the carafe (page 42 -
fig. 7) and fill it with fresh water.
Insert the carafe in the brewing position,
and then press the "OK" button.