Intenza Water Filter - Philips Saeco Xelsis RI9946/47 Mode D'emploi

intenZa Water filter

To improve the quality of the water you use and extend the life of your machine at the same time, it is recommended that you install the
water fi lter. After installation, go to the water fi lter initialization programme (see the "MACHINE MENU", page 31). In this way, the machine
informs the user when the water fi lter must be replaced.
Remove the water fi lter from its packaging, immerse it vertically (with the opening positioned upwards) in cold water and
gently press its sides to let the air bubbles out.
1
Remove the small white fi lter from the
tank and store it in a dry place sheltered
from dust .
4
Fill the tank with fresh drinking water
and re-insert it into the machine .
7
2.4.3. WATER SETTINGS
ESC
ACTIVATE FILTER?
OK
Press the "OK" button.
NOTE: At the end of the procedure the display automatically returns to the product dispensing page.
If the Intenza water fi lter is not available, insert the small white fi lter previously removed (see point 1) into the tank.
2
Set up the Intenza Aroma System:
A = Soft water
B = Medium water (standard)
C = Hard water
5
Place a container beneath the hot water/
steam wand.
8
INSERT WATER FILTER
AND REFILL THE WATER TANK
OK OK
Press the "OK" button to confi rm the
introduction of the new water fi lter.
3
Insert the fi lter in the empty tank. The
reference mark and the groove must
match. Push fi rmly until it is completely
inserted .
6
2.4. WATER SETTINGS
ESC
WATER HARDNESS 3
ENABLE FILTER OFF
ACTIVATE FILTER
OK
Access the "MACHINE MENU" (see page
31). Select "WATER SETTINGS" and
"ACTIVATE FILTER", then press "OK".
9
PLACE A CONTAINER UNDER HOT
WATER & DISP. SPOUT
OK OK
Press the "OK" button to confi rm. Wait
until the cycle is completed and remove
the container .
7