Specifications - Subdrive30 - Franklin Electric SubDrive15 Manuel D'utilisation

Masquer les pouces Voir aussi pour SubDrive15:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SubDrive/MonoDrive

Specifications - SubDrive30

Model No.
NEMA 3R (indoor/outdoor)
Voltage
Phase In
Frequency
Current (max)
Input from
Power Source
Power Factor
Power (idle)*
Power (max)
Wire Gauge Size(s)
Voltage
Phase Out
Output to Motor
Frequency Range
Current (max)
Wire Gauge Size(s)
Factory preset
Pressure
Setting
Adjustment Range
Temperature (at 230 VAC input)
Operating
Conditions
(A)
Relative Humidity
Controller Size
(B)
NEMA 3R
(approximate)
Pump (60 Hz)
For Use With
(C)
FE Motor Rating
Notes:
(A) Operating temperature is specified at full output power when installed as described in Location of Drive on pg. 13-14.
(B) Refer to pg. 25-26 for detailed Drive Mounting.
(C) When a SubDrive30 is used with a single-phase 3-wire motor (see drive selection on pg. 29-31), the MonoDrive pump and motor
specifications on page 5 apply.
* Idle power is defined as input power used by the drive when the drive is not running the motor, the drive fan is off, and no
communication is active. Idle power is increased by 1 W if Wi-Fi is on.
8
SubDrive30
587 020 5403
208/230 VAC
Single-Phase
60/50 Hz
23 A
~ 0.95
5 W
4.2 kW
Consult Federal, State, and Local codes for branch circuit installations
230 VAC
Single-Phase (3-Wire) OR
Three-Phase
30-78 Hz (1.5 hp, 1.1 kW) pump
30-70 Hz (2 hp, 1.5 kW) pump
30-60 Hz (3 hp, 2.2 kW) pump
30-63 Hz (Single-Phase Motors)
10.9 A / phase
See pg. 18 for circuit breaker and wire sizing
50 psi (3.4 bar)
25-80 psi (1.7 - 5.5 bar)
-13 °F to 122 °F (-25 °C to 50 °C)
20-95%, non-condensing
9 3/4" x 19 3/4" x 5 1/4" : 26 lbs
(25 x 50 x 13 cm) : (11.8 kg)
1.0 hp (0.75 kW) pump with 214508-series motor
1.5 hp (1.1 kW) pump with 224300-series motor
2.0 hp (1.5 kW) pump with 224301-series motor
0.75 hp (0.55 kW), 1.0 hp (0.75 kW), or 1.5 hp (1.1 kW) pump with 234514-series motor
1.0 hp (0.75 kW), 1.5 hp (1.1 kW), or 2.0 hp (1.5 kW) pump with 234315-series motor
1.5 hp (1.1 kW), 2.0 hp (1.5 kW), or 3.0 hp (2.2 kW) pump with 234316-series motor
214508-series (1.0 hp, 0.75 kW) single-phase, 3-wire
224300-series (1.5 hp, 1.1 kW) single-phase, 3-wire
224301-series (2.0 hp, 1.5 kW) single-phase, 3-wire
234514-series (1.5 hp, 1.1 kW) three-phase
234315-series (2.0 hp, 1.5 kW) three-phase
234316-series (3.0 hp, 2.2 kW) three-phase

Publicité

Table des Matières
loading

Table des Matières