Advanced Setup (Wi-Fi/Fe Connect Mobile App); Connecting To Wi-Fi - Franklin Electric SubDrive15 Manuel D'utilisation

s
WARNING
!
Serious or fatal electrical shock may result from contact with internal electrical components.
DO NOT, under any circumstances, attempt to modify DIP switch settings until power has been
removed and 5 minutes have passed for internal voltages to discharge! Power must be removed
for DIP switch setting to take effect.
Advanced Setup (Wi-Fi / FE Connect Mobile App)
Some advanced features are able to be modified when connected to the SubDrive/
MonoDrive through Wi-Fi and using the FE Connect mobile app. Follow the instructions
below to connect to the drive and access these advanced settings and features.

Connecting to Wi-Fi

1. The drive's Wi-Fi radio is only able to be connected to within fifteen (15) minutes
following a power-up. If the drive has been powered on for longer than fifteen (15)
minutes, cycle power to the SubDrive/MonoDrive unit.
2. After a few seconds of initialization following power-up, the FE Connect light will
illuminate solid to indicate that a connection is available. The FE Connect light is
located just below the clear window of the display.
3. Open the Wi-Fi connection settings on the device you wish to use to connect to the
drive. This is similar to the method used to connect to a normal Wi-Fi hotspot. In
the list of available Wi-Fi connections locate the hotspot named "FECNCT_XXXXX",
where "XXXXX" is the ending portion of the serial number of the drive being
connected to.
4. Connect to the Wi-Fi hotspot. The FE Connect light on the drive will flash to indicate
that a connection is being made. Only one (1) device can be connected to a drive at
any given time.
Note: The Wi-Fi connection will stay active for an unlimited amount of time as long
as the mobile device is not disconnected from the drive Wi-Fi. If the connection is
broken, the drive Wi-Fi will be available for reconnection for one (1) hour following a
disconnection. If you wish to reconnect to the drive Wi-Fi after an hour has elapsed,
the drive must be power cycled.
SubDrive/MonoDrive
FE Connect Light
33