Accessories - Franklin Electric SubDrive15 Manuel D'utilisation

Accessories

Accessory
Air Screen Kit
Duplex Alternator
Filter (Input)
Filter (Output)
Filter (Surge Capacitors)
Lightning Arrestor
NEMA 3R Fan Replacement Kit
NEMA 3R Fan Replacement Kit
Pressure Sensor
(High: 75-150 psi, NSF 61 rated)
Pressure Sensor
(Standard Replacement: 25-80 psi,
NSF 61 rated)
Sensor Cable Kit (indoor)
Sensor Direct Burial Cable
Tank Drawdown Kit
Pressure Sensor
Input Board Replacement
Detail
Assists in preventing insects from entering and damaging
the internal components of the drive
Allows a water system to alternate between two parallel
pumps controlled by separate SubDrives
Filter used on the input side of drive to help
eliminate interference
Filter used on the output side of the drive to help
eliminate interference
Capacitor used on the service panel to help eliminate
power interference
Single-phase (Input Power)
Replacement fan
Replacement fan
Adjusts pressure in the water system from 75-150 psi
(2-leaded cable)
Adjusts pressure in the water system from 25-80 psi
(2-leaded cable)
100 feet of 22 AWG cable (2-leaded cable)
Designed to be run in a trench underground without the
use of conduit to surround it (4-leaded cable)
Allows the use of water stored in the tank during low
flow demands
Replacement board for drives that have experienced a
surge on the pressure sensor input
SubDrive/MonoDrive
Used with
All Models
All Models
All Models
All Models (excluding SD300)
SD15, SD20, SD30, MD, MDXT
Single-phase (Input Power)
SD15 and MD
SD20, SD30, MDXT
All Models
All Models
SD15, SD20, SD30, MD, and MDXT
All Models - 10 ft (3 m)
All Models - 30 ft (9 m)
All Models - 100 ft (30.5 m)
All Models
All Models
Part Number
226 550 901
585 001 2000
225 198 901
225 300 901
225 199 901
150 814 902
226 545 901
226 545 902
225 970 901
223 995 901
223 995 902
225 800 901
225 800 902
225 800 903
225 770 901
226 540 901
35