Vercise™ DBS Charging Handbook
Using the Adhesive Patch
1
When the indicator light is green, remove the Charger from the Base Station.
(The indicator light will go off, regardless of the ready status of the Charger.)
2
Apply the Adhesive Patch to the backside of the Charger by peeling the clear liner
from the patch and applying the white side with the blue stripe to the rear of the
Charger, as shown.
3
Remove the skin side beige liner from the adhesive (only good for one fixation).
4
For best charging results, make sure the Charger is centered over the Stimulator.
If the Charger is not centered, charging time may increase. See sections Properly Aligning the Charger and Tips
for Properly Aligning the Charger to ensure you center the Charger over the Stimulator. It is recommended that you
follow the instructions in both sections the first time you charge your Stimulator.
Note: Do not put the Charger directly on the skin (e.g., without an Adhesive Patch).
Vercise™ DBS Charging Handbook
91171709-02
Page 10 of 79