Bosch 800 Serie Manuel D'utilisation page 31

Inserting the probe:
Insert the tip of the probe in the middle and thickest part
of the meat or the breast for poultry. Make sure the probe
is not touching fat, bone or parts of the oven or the pan.
Note: Food must be completely thawed before inserting
the probe into the meat.
To use the probe:
Insert the probe into the meat as described above. The
1.
probe symbol is displayed.
Connect the probe to the oven. If the probe is not
2.
connected to the oven prior to starting Probe mode, an
error tone sounds and the message "INSERT PROBE"
is displayed.
Set the cooking mode and temperature.
3.
The Set Probe Temp screen is displayed. A three digit
4.
input prompt "- - -" blinks in the lower right corner. Use
the numeric keypad to enter the desire probe
temperature and press Enter.
Note: The minimum probe temperature that can be
set is 100°F (40°C) and the maximum is 200°F
(100°C). If the probe temperature entered is outside
this range, an error is displayed.
The probe current temperature and target temperature
5.
are both displayed in the format "105/180" at the
lower right corner of the display. The actual
temperature will display <80 until the food temperature
reaches 80°F.
The displayed probe temperature is updated in
increments of 5° during the cooking process.
When the probe temperature reaches the set
6.
temperature, the cooking mode turns off. The current
time is displayed and the message "COOKING
COMPLETE" blinks at the bottom left of the display. An
alarm tone sounds every 10 seconds for 2 minutes.
This screen remains in the display until it is cleared by
pressing the Oven Clear/Off button or until the probe
is removed. The display then goes back to Standby
mode.
Notes
Probe is not available when an Oven Timer has
▯
been set.
To change the probe temperature, press the Probe
▯
button. The display enters probe temperature
editing mode and displays the message "SET
PROBE TEMP". Enter the new probe temperature
and press Enter to accept the new value.
Do not store the probe in the oven.
▯
Always use the handle of the probe for inserting and
▯
removing.
Always use a potholder to remove the probe since it
▯
becomes hot.
Since meat continues to cook after being removed
▯
from the oven, set the internal (probe) temperature
5°-10° below the desired final internal temperature
except with poultry.
31