Human Touch Perfect Chair PC-600 Mode D'emploi Et D'entretien page 8

6. Plug the transformer into the right-hand power hub receptacle (Fig.13).
Fig.13
7. Feed the transformer cable up through the cable guide then up through the hole in the chair
canvas (Fig.14).
8. Gently return the chair to the upright position.
Fig.14
humantouch.com
Plug in transformer
Feed transformer cable
12
S P
C
Install the control panel and arm caps
NOTE: Comfort Upholstery Package does not have a control panel; follow steps 1 - 4, 6, 7, 10 and 11
to install the arm caps and lower body pad.
1. Remove the six screws taped to the underside of the left-hand armrest cap.
2. Note the shape of the top of the recline controller panel and the matching shape of the
recline controller housing (Fig.15).
Recline controller housing
3. Place the housing into position on the left-hand armrest as shown (Fig.16).
4. Make sure the matching shapes are tightly aligned to ensure that the knob is centered in the housing.
Recline controller panel
Fig.15
Recline controller housing
Fig.16
13 13